# SPDX-FileCopyrightText: Copyright (c) 2020 Bryan Siepert for Adafruit Industries
#
# SPDX-License-Identifier: MIT
"""This example shows off how to use the step counter built
into the ST LSM6DS series IMUs. The steps are calculated in
the chip so you don't have to do any calculations!"""

import time

import board

from adafruit_lsm6ds import AccelRange, Rate

# pylint:disable=no-member
# Import the correct class for the sensor that you have.
# Change the import as needed. Not all are listed here.
# Note that the LSM6DS3TRC, which is used on the Adafruit Feather Sense,
# uses a different I2C register to enable the pedometer,
# so the device classes are not interchangeable.
#
# from adafruit_lsm6ds.lsm6ds33 import LSM6DS33 as LSM
from adafruit_lsm6ds.lsm6ds3trc import LSM6DS3TRC as LSM

i2c = board.I2C()  # uses board.SCL and board.SDA
# i2c = board.STEMMA_I2C()  # For using the built-in STEMMA QT connector on a microcontroller
sensor = LSM(i2c)

# enable accelerometer sensor @ 2G and 26 Hz
sensor.accelerometer_range = AccelRange.RANGE_2G
sensor.accelerometer_data_rate = Rate.RATE_26_HZ
# no gyro used for step detection
sensor.gyro_data_rate = Rate.RATE_SHUTDOWN

# enable the pedometer
sensor.pedometer_enable = True

while True:
    print("Steps: ", sensor.pedometer_steps)
    time.sleep(1)