# SPDX-FileCopyrightText: 2021 ladyada for Adafruit Industries
# SPDX-License-Identifier: MIT

# Use this example for digital pin control of an H-bridge driver
# like a DRV8833, TB6612 or L298N.

import time

import board
import digitalio

from adafruit_motor import stepper

DELAY = 0.01
STEPS = 200

# You can use any available GPIO pin on both a microcontroller and a Raspberry Pi.
# The following pins are simply a suggestion. If you use different pins, update
# the following code to use your chosen pins.

# To use with CircuitPython and a microcontroller:
coils = (
    digitalio.DigitalInOut(board.D9),  # A1
    digitalio.DigitalInOut(board.D10),  # A2
    digitalio.DigitalInOut(board.D11),  # B1
    digitalio.DigitalInOut(board.D12),  # B2
)

# To use with a Raspberry Pi:
# coils = (
#     digitalio.DigitalInOut(board.D19),  # A1
#     digitalio.DigitalInOut(board.D26),  # A2
#     digitalio.DigitalInOut(board.D20),  # B1
#     digitalio.DigitalInOut(board.D21),  # B2
# )

for coil in coils:
    coil.direction = digitalio.Direction.OUTPUT

motor = stepper.StepperMotor(coils[0], coils[1], coils[2], coils[3], microsteps=None)

for step in range(STEPS):
    motor.onestep()
    time.sleep(DELAY)

for step in range(STEPS):
    motor.onestep(direction=stepper.BACKWARD)
    time.sleep(DELAY)

for step in range(STEPS):
    motor.onestep(style=stepper.DOUBLE)
    time.sleep(DELAY)

for step in range(STEPS):
    motor.onestep(direction=stepper.BACKWARD, style=stepper.DOUBLE)
    time.sleep(DELAY)

for step in range(STEPS):
    motor.onestep(style=stepper.INTERLEAVE)
    time.sleep(DELAY)

for step in range(STEPS):
    motor.onestep(direction=stepper.BACKWARD, style=stepper.INTERLEAVE)
    time.sleep(DELAY)

motor.release()