# SPDX-FileCopyrightText: Melissa LeBlanc-Williams for Adafruit Industries
# SPDX-License-Identifier: MIT

# This example is for use on (Linux) computers that are using CPython with
# Adafruit Blinka to support CircuitPython libraries. CircuitPython does
# not support PIL/pillow (python imaging library)!
#
# Ported to Pillow by Melissa LeBlanc-Williams for Adafruit Industries from Code available at:
# https://learn.adafruit.com/adafruit-oled-displays-for-raspberry-pi/programming-your-display

# Imports the necessary libraries...
import time

import board
import digitalio
from PIL import Image, ImageDraw, ImageFont

import adafruit_ssd1306

# Setting some variables for our reset pin etc.
RESET_PIN = digitalio.DigitalInOut(board.D4)

i2c = board.I2C()  # uses board.SCL and board.SDA
# i2c = board.STEMMA_I2C()  # For using the built-in STEMMA QT connector on a microcontroller

# Create the SSD1306 OLED class.
# The first two parameters are the pixel width and pixel height.
# Change these to the right size for your display!
oled = adafruit_ssd1306.SSD1306_I2C(128, 64, i2c)

# Note you can change the I2C address, or add a reset pin:
# oled = adafruit_ssd1306.SSD1306_I2C(128, 64, i2c, addr=0x3D, reset=RESET_PIN)

# Clear display.
oled.fill(0)
oled.show()

# Create blank image for drawing.
image = Image.new("1", (oled.width, oled.height))
draw = ImageDraw.Draw(image)

# Load a font in 2 different sizes.
font = ImageFont.truetype("/usr/share/fonts/truetype/dejavu/DejaVuSans.ttf", 16)
font2 = ImageFont.truetype("/usr/share/fonts/truetype/dejavu/DejaVuSans.ttf", 24)

offset = 0  # flips between 0 and 32 for double buffering

while True:
    # write the current time to the display after each scroll
    draw.rectangle((0, 0, oled.width, oled.height * 2), outline=0, fill=0)
    text = time.strftime("%A")
    draw.text((0, 0), text, font=font, fill=255)
    text = time.strftime("%e %b %Y")
    draw.text((0, 14), text, font=font, fill=255)
    text = time.strftime("%X")
    draw.text((0, 36), text, font=font2, fill=255)
    oled.image(image)
    oled.show()

    time.sleep(1)

    for i in range(0, oled.height // 2):
        offset = (offset + 1) % oled.height
        oled.write_cmd(adafruit_ssd1306.SET_DISP_START_LINE | offset)
        oled.show()
        time.sleep(0.001)